I'd like some advice please, I've never been inside a pickup before
I have a chinabucker that has ceased giving an output, looking at the back its quite obviously the loose wire at the top, but when I compare it to a fresh out of the bag one it appears slightly different
on the new one the two wires disappear into the two holes , on the broken one where the loose wire looks like it should go into, the hole is obscured by flat metal that resists all poking and prodding
is there a part that could have come loose and sheared the wire and got lodged over the hole?
it looks like the cover is just held on by 4 bits of solder, can I melt/suck the solder off and remove the cover, and if so will I be able to access the contact that the broken wire needs reconnecting to?
Broken chinabucker
new chinabucker