Binding and scraping time.
Broke the top strip three times, tried to force the bends. I use acetone ( in poly bottle with needle applicator) to cement the ABS in the rabbet and binding tape from Allparts to hold in place for the short setting time.Binding was 6mm tall. I cut the rabbets 4mm deep and then scraped installed binding down to that height. Panel scraper made quick work of most of it. Clamp is holding broken binding strip to tip of top horn.
Back went much smoother, one continuous no break strip using a 30 year old hair dryer to soften the ABS while making the bends. 2" scrap was all that was left over. Butt joint at center of heel.
Rough out work done. Acetone sets up almost as fast as super glue, as well as costing next to nothing.