991
Bill's Shop: Projects, Mods & Repairs / Re: Technical question
« on: October 28, 2016, 12:10:46 PM »
It sounds a little harmonic. Does it feedback?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
992
Bill's Shop: Projects, Mods & Repairs / Re: CURRENT CATALDO
« on: October 27, 2016, 04:25:00 PM »Heck, I like the thin white accent!Same here but the white is nice contrast.
But I think I'd like it either way.
993
Bill's Shop: Projects, Mods & Repairs / Re: CURRENT CATALDO
« on: October 21, 2016, 05:45:28 PM »
"I mixed flat black primer/surfacer with gloss white nitro and Mohawk 'Flash Off. "
THAT's a flash of creativity.
THAT's a flash of creativity.
995
Gibson Basses / Re: Music videos that feature Gibson Les Paul basses...
« on: October 21, 2016, 05:38:45 PM »I gotta say: Longhorns work much better for me as a guitar than a bass.
Me 2 but they were good when tracked against uprights in early R&R
996
Bill's Shop: Projects, Mods & Repairs / Re: Lowe Shop Notes
« on: October 11, 2016, 04:27:56 PM »
Post some of your art guitars Brad
997
Gibson Basses / Re: Poor sweet baby.
« on: October 09, 2016, 05:18:23 PM »Thanks, Baz...I think I have it covered. It's going to be a NOS clone of my '77, even the three point. Method to be determined upon inspection.
I'm not going to remove the existing wings if I don't have to. Main reason for that is the P route needs to be filled and no matter how it's done it won't be 'original'.
998
Other Bass Brands / Re: Jim Cairnes Colt Bass
« on: October 07, 2016, 04:35:00 PM »Uwe, the King of the Ümläüt!HAHAHAHAHA
1001
The Outpost Cafe / Re: More bad news for AC/DC
« on: September 23, 2016, 04:33:23 PM »
Absolutely PERFECT 
1002
Bill's Shop: Projects, Mods & Repairs / Re: Grove Guitars tribute build - LowkASAT crate top
« on: September 22, 2016, 06:08:25 PM »
Sweet!
1003
Bill's Shop: Projects, Mods & Repairs / Re: refixing fingerboard
« on: September 22, 2016, 06:07:04 PM »
If it is just a crack and not loaded with crud try squeezing it closed dry to see if it will even close. I would not dilute tightbond but rather wick a drop of CA.
1004
Bill's Shop: Projects, Mods & Repairs / Re: refixing fingerboard
« on: September 19, 2016, 04:30:59 PM »
more clamps than tou might imagine.
Consider a small nail in each end of the neck, cut off and sharpened. Press the fingerboard onto these pins to prevent it board sliding with the clamps.
Consider a small nail in each end of the neck, cut off and sharpened. Press the fingerboard onto these pins to prevent it board sliding with the clamps.
1005
Fender Basses / Re: Mustang basses... any fans?
« on: September 19, 2016, 04:27:24 PM »
Very nice