Fender Saddle Setscrews....

[Pilgrim]

I think you could get some of that plastic stuff that's used to clinch the end of cut ropes and dab a bit onto the end of the set screw.  It comes in small cans at Home Depot and ACE Hardware (I think). That would give you a non-abrasive coating that would be easy to remove if/when adjustments are needed.

[nofi]

nail polish works just fine. used it alot on the 60's and 70's fenders i had but the newer ones don't seem to need it.

[dadagoboi]

Heat shrink tube.  Just make it slightly taller than the top of each screw.  You'll still be able to adjust them.

[Rob]

Heat shrink tube.  Just make it slightly taller than the top of each screw.  You'll still be able to adjust them.

Great idea!

[dadagoboi]

Great idea!

Thanks, Al's mention of plastic dip was what triggered it.

[Pilgrim]

Heat shrink tube.  Just make it slightly taller than the top of each screw.  You'll still be able to adjust them.

Yassir, that orts t'work.