Here's the second Phantom clone and my original side by side. They both weigh 9.2 lbs and balance great. Steve of ThunderBucker Ranch made the repro bridge cover. Seymour Duncan single coil Precision pups are inside the covers I scratch built from modelers' styrene sheet. Allparts rosewood board P width paddle head neck, hipshot ultralites.
The 'toilet handle' is connected to a blend pot, there's quite a bit of tone variation from it, much more than a 3 position switch. The VOX has a 2 position switch, bridge OR neck. On the one I played in the 70s I added 2 more pots and bypassed it.
Sound is pretty close to the original. I have an old set of Bass Burners on the Vox and a fresh set of EXL170 on the clone so it's not a fair comparison. The bridges are threaded saddle on both, VOX copied Fender but with narrower spacing. I like the wider spacing on the clone, the strings on the Vox are really close to the board edge on the upper frets, there's very little taper to the neck.