OK, the pickups are in and wires run on the EB-0 - I have an original Gibson humbucker in the neck position and a Model One in the bridge position.
My goal is to connect each pickup to a pot with push/pull switch, and work without a tone control for now. With the sound I'm likely to get out of this combination of pickups, I doubt that I will need to roll off the treble from the signal.
SO - I need to figure out how to wire this. I'm part-way there but am puzzled with how to proceed.
For the Gibson pickup, I really don't need a push-pull, but I have one so I installed it. All I need to do with that pot is leave it in the "push" position and let the signal go through.
For the Model One, I have four wires which don't conform to Dimarzio's normal color scheme: Black / Red / White / Bare. But the pickup is 20+ years old and I assume they've changed it. From testing with an ohm meter, it appears that Black and Red are a pair, and White and Bare are a pair. I want to wire the the connections on the push/pull for the Model One so that UP is one coil of the pickup, DOWN is both coils.
This diagram reflects what I have done so far...but I need help completing it. I'm confused because I can't find any diagrams without tone pots after a pair of humbucker controls.
Here's a direct link to the file:
http://i83.photobucket.com/albums/j306/apowell1/Electric%20Basses/EB-02small.jpgI suspect that I have the Model One wired wrong in any case...but if one of you folks who really understand wiring could help me get these wired as described above and connect to the output jack, I'd br grateful. I have labeled each push/pull contact with letters A-F, and terminals on the pots 1-3.
Ideas?