I've seen the Veritas before too. It does look much more substantial than the Daisy, which looks like it might be okay for very light work only. Too bad you can't buy the regular guide pins separately.
Yeah, the guide pins and the receiver they fit into are first class. The receiver is also retractable, so you can raise the pin and remove the work piece easier. The problem with the arm is the attachment screws which go into a clamp on the end of the arm.
After centering the arm over the router's center, you then have to tighten the arm mounting screws into the clamp mechanism. Every time you tighten the screws, the arm/clamp move ever so slightly and screws up the alignment by a few hundredths of an inch. It is maddening! I think the best way is to leave the clamp off and put screw directly through the arm holes into the table. I'm going to try that sometime just to see if it works.
Right now, I'm really happy with my homemade set up and it's easy to remove and set back up!