'78 Gibson Grabber bridge problems

[uwe]

I'll see what I can do.   At the least I'll refund your excess Paypal.

Don't bother, it's alright. I'm happy to have those screws.

[FrankieTbird]

   
I didn't realize the OP was looking for saddle height screws.  In that case, these may work out a little better, even if they're a little shorter:

http://www.mcmaster.com/#91375a119/=rkdwwe
 

[uwe]

Those are perfect with the hex socket and all!

But 25 of them for only 10 dollars? My paper pushing self is repelled in tech ignorance!!!!

[Ampig]

   
I didn't realize the OP was looking for saddle height screws.  In that case, these may work out a little better, even if they're a little shorter:

http://www.mcmaster.com/#91375a119/=rkdwwe
 

I'm looking for all the bridge screws actually 

@Uwe: maybe we can split one order of saddle height screws if you need them?

[dadagoboi]

I'm looking for all the bridge screws actually 

By 'all' do you mean the saddle length adjusters or the plate mounting screws?

Length adjusters are 4-48 x 1.25 inch slotted pan heads on my '75.  Mounting screws are #6 x .75 inch oval head phillips nickel plated.

edited for screw length

[dadagoboi]

Pack of 50 Stainless steel 1" fillister heads, $12.46.  UPS shipping 350 miles, $6.50.  Would have cost close to $10 to ship to the west coast from McMaster.



Installed, same 3/4" thread length as originals.  Less likely to tear up a muting hand or rust compared to headless steel.  Fit under stock bridge cover.

[uwe]

I'm looking for all the bridge screws actually 

@Uwe: maybe we can split one order of saddle height screws if you need them?

Sure, I'll probably order two packs in any case. Will do after Easter.